4.3-10 Male Right Angle Connector for 1/2" Hi-Flex Cable, O-Ring Type, 1 ea
The connector is designed according the standard interface as 4.3-10. Contact components are silver or trimetal plated to minimize insertion loss and passive intermodulation products
The connectors are designed with the standard interfaces such as N, 4.3-10, or DIN 7-16. The contact components are coated with silver or trimetal to reduce the loss of signal and unwanted interference. The mechanical parts are covered with a layer of nickel to ensure durability and protection against corrosion. Watertightness is achieved simultaneously on the outer conductor and on the jacket by using a special silicone gasket. This watertight solution allows the use of ours connectors in the toughest environmental conditions. For a convenient and dependable installation that is also cost-effective, special trimming tools are highly recommended.
- Low reflection coefficient (up to 3.0 GHz)
- Low PIM level
- High contact force through inner contacts made in a high-strength copper alloy
- Provides watertight seal, ensuring protection against moisture and dust (IP67/IP68)
- Resistant to corrosion, maintaining long-lasting functionality
- Quick trimming tool for cable preparation
- Installation ”screw it on and tighten it”
Electrical characteristics:
Nominal impedance, Ohm:
50
Reflection coefficient @ 3 GHz, db:
≥34
Working voltage:
1 - 2.7 kV rms, 50 Hz (see pdf spec sheet)
Max peak power:
10 - 40 kW (see pdf spec sheet)
Temperature range:
-40°F to +185°F (-40°C to +85°C)
External parts materials
Brass with passivated silver or trimetal or electroless nickel plating
Outer contact:
Brass with passivated silver or trimetal plating
Inner contact:
Passivated silver plated high-strength copper alloy and brass
Dielectric:
TXP / PTFE
O-Rings:
High quality silicone
Special trimming tool:
SPTC50B12X
Similar or Related Products:
These models may be compatible with your equipment:
Eupen-cable-connectors-installation-manual.pdf (2567.91 KB)
