N Female Connector for 1/2" Hi-Flex Cable, O-Ring Type, 1 ea
The connector is designed according the standard interface as N. Contacts components are silver or trimetal plated to minimize insertion loss and passive intermodulation products
The connectors are designed with the standard interfaces such as N, 4.3-10, or DIN 7-16. The contact components are coated with silver or trimetal to reduce the loss of signal and unwanted interference. The mechanical parts are covered with a layer of nickel to ensure durability and protection against corrosion. Watertightness is achieved simultaneously on the outer conductor and on the jacket by using a special silicone gasket. This watertight solution allows the use of ours connectors in the toughest environmental conditions. For a convenient and dependable installation that is also cost-effective, special trimming tools are highly recommended.
- Low reflection coefficient (up to 3.0 GHz)
- Low PIM level
- High contact force through inner contacts made in a high-strength copper alloy
- Provides watertight seal, ensuring protection against moisture and dust (IP67/IP68)
- Resistant to corrosion, maintaining long-lasting functionality
- Quick trimming tool for cable preparation
- Installation ”screw it on and tighten it”
Electrical characteristics:
Nominal impedance, Ohm:
50
Reflection coefficient @ 3 GHz, db:
≥34
Working voltage:
1 - 2.7 kV rms, 50 Hz (see pdf spec sheet)
Max peak power:
10 - 40 kW (see pdf spec sheet)
Temperature range:
-40°F to +185°F (-40°C to +85°C)
External parts materials
Brass with passivated silver or trimetal or electroless nickel plating
Outer contact:
Brass with passivated silver or trimetal plating
Inner contact:
Passivated silver plated high-strength copper alloy and brass
Dielectric:
TXP / PTFE
O-Rings:
High quality silicone
Special trimming tool:
SPTC50B12X
Similar or Related Products:
These models may be compatible with your equipment:
Eupen-cable-connectors-installation-manual.pdf (2567.91 KB)
