Item Details: 
 
Eupen 1/2 inch Hi-Flex Coaxial Cable Connectors
The connectors are designed with the standard interfaces such as N, 4.3-10, or DIN 7-16. The contact components are coated with silver or trimetal to reduce the loss of signal and unwanted interference. The mechanical parts are covered with a layer of nickel to ensure durability and protection against corrosion. Watertightness is achieved simultaneously on the outer conductor and on the jacket by using a special silicone gasket. This watertight solution allows the use of ours connectors in the toughest environmental conditions. For a convenient and dependable installation that is also cost-effective, special trimming tools are highly recommended.
Available as:
    
      
        | 4.3-10M50B12X | 
        4.3-10 male, hiflex, 1/2" connector | 
      
      
        | 7/16F50B12X | 
        7/16 DIN female, hiflex, 1/2" connector | 
      
      
        | 7/16M50B12X | 
        7/16 DIN male, hiflex, 1/2" connector | 
      
      
        | 7/16M50BL12X | 
        7/16 DIN male, hiflex, right angle, 1/2" connector | 
      
	        
        | NF50B12X | 
        N female, hiflex, 1/2" connector | 
      
      
        | NM50B12X | 
        N male, hiflex, 1/2" connector | 
      
      
        | NM50BL12X | 
        N male, hiflex, right angle, 1/2" connector | 
      
    
Features:
- Low reflection coefficient (up to 3.0 GHz)
- Low PIM level
- High contact force through inner contacts made in a high-strength copper alloy
- Provides watertight seal, ensuring protection against moisture and dust (IP67/IP68)
- Resistant to corrosion, maintaining long-lasting functionality
- Quick trimming tool for cable preparation
- Installation ”screw it on and tighten it”
Electrical characteristics:
    
      
        | Nominal impedance, Ohm: | 
        50 | 
      
      
        | Reflection coefficient @ 3 GHz, db: | 
        ≥34 | 
      
      
        | Working voltage: | 
        1 - 2.7 kV rms, 50 Hz (see pdf spec sheet) | 
      
      
        | Max peak power: | 
        10 - 40 kW (see pdf spec sheet) | 
      
      
        | Temperature range: | 
        -40°F to +185°F (-40°C to +85°C) | 
      
      
        | External parts materials | 
        Brass with passivated silver or trimetal or electroless nickel plating |      
      
      
        | Outer contact: | 
        Brass with passivated silver or trimetal plating | 
      
      
        | Inner contact: | 
        Passivated silver plated high-strength copper alloy and brass | 
      
      
        | Dielectric: | 
        TXP / PTFE | 
      
      
        | O-Rings: | 
        High quality silicone | 
      
      
        | Special trimming tool: | 
        SPTC50B12X |