Telewave Inc ANT900D7-12DIN
800-1000 MHZ DIPOLE ANTENNA
Telewave-ANT900D-series-antennas.pdf (73.86 KB) Telewave-antenna-connection-weatherproofing.pdf (177.98 KB)Telewave ANT900D7-12
DIPOLE AND DIPOLE ARRAY 1 TO 9 dBd
The Telewave ANT900D7-12
antenna consists of single, dual, and 4-element dipole array antennas with a
precision phasing harness for optimum performance. The antenna horizontal
pattern is field adjustable, for any current or future coverage requirements.
The wide bandwidth and high efficiency of these antennas make them ideal for
many applications, including trunking, cellular, data, and paging.
Each dipole element is
constructed with 6061-T6 aluminum, fully welded to prevent intermodulation. The
2 and 4 element arrays utilize a power divider for minimum loss. Each antenna
is also completely sealed with our high-tech Txylan™ coating, which resists
water and ice buildup, and provides exceptional protection from corrosive
gases, UV radiation, salt spray, acid rain and windblown abrasives.
Each element includes a
heavy-duty custom clamp set for mounting to a 0.5”-1.5” diameter galvanized
steel support pipe or tower leg.
Up to 15 degrees of
electrical uptilt or downtilt may be specified for D3 or D6-9 models. Desired tilt
angle must be included on the order, and consultation with our antenna
engineering staff is requested.
Installed Height 86”.
Standard connector is N-Male on a pigtail (8 bay arrays and ANT900Dxx terminate
with N-Female or DIN-F on power divider). 7-16 DIN available (additional cost).
All dipoles and arrays are field-configurable and UPS shippable, and include
clamps for mounting to an existing mast or other support. 2 and 4 bay arrays
can be ordered with up to 15 degrees of electrical uptilt or downtilt.
COMMON SPECIFICATIONS
Frequency (continuous), MHz: 800
- 1000
Power rating (typ.), W: 500
Impedance, ohm: 50
VSWR: 1.5:1
or less
Pattern: Adjustable:
Offset circular, cardioid, or bidirectional
Lightning protection: DC
Ground
Termination: N-Male
or 7-16 DIN (opt.) on harness feed cable
Wind rating, MPH: 200
(with 0.5” ice), MPH: 175
MODEL
SPECIFICATIONS
Gain (dependent on pattern), dBd: 7
– 12
Vertical beamwidth (3/8 wl.): 35°
Dimensions (H x D) max, in.: 21
x 6
Weight (antenna + clamps), lb.: 7
Maximum exposed area, ft.І: 0.2
Lateral thrust at 100 MPH, lb.: 9
Telewave Inc. designs and manufactures high quality RF system products. It serves wireless system operators, public safety providers, local and state governments, and federal agencies in the United States and internationally. The company was founded in 1972 and is based in San Jose, California. Telewave strives to be the premier supplier of seamless interoperable communication systems that provide security and reliability in mission critical eco-systems for both commercial and military applications worldwide. Telewave products are used by more than 7,500 equipment and network manufacturers and government agencies throughout the world.
| ANT900D7-12DIN | 800-1000 MHZ DIPOLE ANTENNA |
| TK-372GK1SK | TK-372G UHF Portable, 450-470 MHz 4W, 32 Ch., includes KNB-15ABK battery, KBH-8 spring belt clip, 110V regular rate charger |
| EH-189SC | Pryme EH-189SC, Listen ONLY earpiece. Industrial jacketed cable, strain relief, 14" Coiled Cord with 3.5mm Right Angle Connector |
| GPS-4133QD | PRYME GPS-4100P GPSMIC Speaker Microphone, Water Resistant Construction, 3.5mm Earphone Jack for Listen-Only Accessories, with Quick Disconnect feature |
| 3652B-350 | Nylon Carry Case with Swivel |
| Bee-6288B-C | Bee Electronics 6288B-C Leather carry case, with Clip. For Icom ICF10, F20 radio(s) |
| ESK-2WPM-MT1 | 2-Wire Audio Surveillance Kit with Quick Disconnect Tube and Palm Microphone |
| URFR6000 63 | UHF 400-470 MHz Repeater Channel Module |
| EC1M-V2-BK1 | Endura In-Vehicle Charger with Replaceable Pod |
| BP4974 | 2.6V @ 170mAh NiCd Battery |
Facebook
YoutubeCopyright © 1991-2026 American Communication Systems, Inc. Patent and other rights reserved. |
